![]() Position the resistors in the right place, you don't have to pay attention to the installation direction. Metalmeccanici: piattaforma sindacati per contratto, aumento 8īend the legs of the resistors immediately at the body, so they fit well on the board. ![]() Do not mix the resistors, otherwise you will have a lot of work. It is better if you cut through the paper so that you separate all resistors, then you can remove the paper without bending the legs crooked. The resistors are usually delivered glued on a paper tape. ![]() Did you use this instructable in your classroom? Add a Teacher Note to share how you incorporated it into your lesson. In the second tutorial we will install this Controller into the control of a China CNC milling machinewith frequency converter and high frequency spindle.
0 Comments
Leave a Reply. |